위모트(Wii Remote) 설정방법

위모트(Wii Remote) 설정방법

원문 : http://www.wiili.org/index.php/How_To:_BlueSoleil

This tutorial will show you how to set up and connect to your Wiimote with BlueSoleil.

The version of BlueSoleil used in this tutorial (and has been tested on) is 1.6.2.1

Download BlueSoleil

• You can download the latest BlueSoleil drivers from their website.
• Or you can find different versions of it on FileMirrors.

BlueSoleil Tutorial

• First, start up the BlueSoleil software and activate your Bluetooth adapters if needed.
  

• Then hit the 1+2 buttons on your Wiimote and click the center orange circle. It will take a few seconds and then find it.
• Note: Make sure that the 4 LEDs on the bottom of the Wiimote are blinking during this whole process. Since the Wiimotes only stay on discover mode for several seconds, you can either hold down the 1+2 buttons the whole time or press them every few seconds.

• If BlueSoleil does not detect your Wiimote, Unplug your bluetooth device and plug it back in. Then press the center orange circle and try again.

• Right click the Wiimote (NINTENDO-RVT-CNT-01) that shows up and click Refresh Services.
• Should this not work, press 1+2 on the Wiimote and simply click on the Wiimote's icon in BlueSoleil

• Click the Bluetooth HID button that shows up at the top and you are done! Now you can use your Wiimote with programs such as GlovePIE and WiinRemote.

Alternative Solution

This is with bluesoleil installed, and this is how you can make your wiimote work without opening or launching bluesoleil! Make sure Bluesoleil is closed before doing this.

1.) Go to your computer's control panel, and open the bluetooth device cp..(see icon)

2.) A dialogue will come up, click on "add device" button. (see image)

3.) Click the checkbox as seen on this image.

4.) Click next, and hold your Wiimote's 1 & 2 buttons together... or better, open up the back of your wiimote and press the sync button and hold it..and the device will appear as here.

5.) Select the new device and click next, DONT LET go of the 1 & 2 buttons or the sync buttons yet! Click the "no passcode" selection and press next..while NOT letting go of the buttons. If you're confused, look at this image.

6.) Your computer will now add the device accordingly, do not let go of the buttons until everything is set up.. no, you dont let go of it until you are back in the window where it says "add devices". If you successfully performed this, your Wiimote will register as "connected" and you are able to use it with GlovePie.

Note: If you are unable to use it, even though the control panel says your device is connected - make sure that the "bluetooth fix" is selected in glovepie.